~$ nc -l -u -p 6666 U-Boot 2011.12 (Feb 12 2012 - 21:33:07) Seagate FreeAgent DockStar arm-none-linux-gnueabi-gcc (Sourcery G++ Lite 2009q3-67) 4.4.1 GNU ld (Sourcery G++ Lite 2009q3-67) 2.19.51.20090709 Hit any key to stop autoboot: 0 (Re)start USB... USB: Register 10011 NbrPorts 1 USB EHCI 1.00 scanning bus for devices... 4 USB Device(s) found scanning bus for storage devices... 2 Storage Device(s) found ** Bad partition 1 ** ** Unable to use usb 0:1 for fatload ** Creating 1 MTD partitions on "nand0": 0x000002500000-0x000010000000 : "mtd=3" UBI: attaching mtd1 to ubi0 UBI: physical eraseblock size: 131072 bytes (128 KiB) UBI: logical eraseblock size: 129024 bytes UBI: smallest flash I/O unit: 2048 UBI: sub-page size: 512 UBI: VID header offset: 512 (aligned 512) UBI: data offset: 2048 UBI: attached mtd1 to ubi0 UBI: MTD device name: "mtd=3" UBI: MTD device size: 219 MiB UBI: number of good PEBs: 1751 UBI: number of bad PEBs: 1 UBI: max. allowed volumes: 128 UBI: wear-leveling threshold: 4096 UBI: number of internal volumes: 1 UBI: number of user volumes: 0 UBI: available PEBs: 1730 UBI: total number of reserved PEBs: 21 UBI: number of PEBs reserved for bad PEB handling: 17 UBI: max/mean erase counter: 1/1 UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:rootfs", error -19 Error reading superblock on volume 'ubi:rootfs'! ** Bad partition 1 ** Loading file "/boot/uImage" from usb device 1:1 (usbdb1) 1 bytes read Found bootable drive on usb 1:1 Loading file "/boot/uImage" from usb device 1:1 (usbdb1) 2082244 bytes read Loading file "/boot/uInitrd" from usb device 1:1 (usbdb1) 9642915 bytes read ## Booting kernel from Legacy Image at 00800000 ... Image Name: kernel 3.16.0-4-kirkwood Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2082180 Bytes = 2 MiB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK ## Loading init Ramdisk from Legacy Image at 01100000 ... Image Name: ramdisk 3.16.0-4-kirkwood Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 9642851 Bytes = 9.2 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ...